The 8754A Network Analyzer is a complete stimulus/response test system which combines a 4-1300 MHz swept source, three-input narrow band, tuned receiver, and both rectilinear and polar displays in a compact package. The convenient built-in source incorporates digital display of the start or center frequency, the ability to sweep all or any portion of the 4-1300 MHz range, and crystal markers at 1, 10, or 50 MHz intervals to enable accurate frequency calibration and measurement. The receiver provides 80 dB dynamic range in two independent measurement channels to allow simultaneous measurement of any two transmission or reflection parameters using a single test setup. Measurements of absolute power, magnitude ratio, phase angle, and reflection coefficient (or return loss) are displayed on the fully calibrated CRT with resolutions up to 0.25 dB and 2.5 degrees per major division. Frequency range 4 to 1300 MHz. Sweep modes linear full sweep and calibrated sweep widths with variable start or center frequency. Sweep widths 1 to 1000 MHz in a 1, 2, 5 sequence, plus CW, plus vernier. Spectral Purity +10 dBm RF output level Residual FM ²7 kHz rms (10 kHz bandwidth) Harmonics -28 dBc Output power range 0 to +13 dBm typical, ±0.5 dB flatness Call for other available options including option 26 which extends frequency to 2.6 GHz! Also available: HP 8748A S-Parameter Test Set to measure both forward and reverse S-Parameters.