For 50 Ohm and 1 Megaohm Interfaces
True Signal Fidelity, DC up to 900 MHz
1.5 pF Input C*1
1 megaohm Input R*1:
Variable DC Offset, up to ±200 V
Selectable 50 Ohm, Termination for Use with 50 Ohm or 1 megaohm Inputs
Digital Design and Debug of Logic Families
Component Characterization/Measurement of High-speed Analog Circuitry
Digital Design and Debug of Logic Families such as:
MOS: CMOS; FastCMOS; BiCMOS
Component Characterization/Measurement of High-speed Analog Circuitry Relative to:
Propagation Delay and Timing
Bandwidths and Rise Times
The P6201 and P6202A are Low Circuit Loading Active Signal Acquisition probes for Tektronix 400 Series, 2400 Series and 7000 Series Families of Oscilloscopes.
The P6201 and P6202A with Active FET devices in their inputs provide very high input impedances.
Both the P6201 and P6202A probes provide a wide linear dynamic input range for accessing most digital device families using today's logic voltage levels.
The P6201 provides unity gain (1X) and is the best general purpose FET probe within its voltage range. Plug-on attenuator heads provide wider dynamic ranges (10X and 100X), while maintaining the oscilloscope readout factor.
Wider dynamic input range for the P6202A is achieved by an optional 10X attenuator head which provides 100X attenuation.
Both the P6201 and P6202A probes provide a variable DC Offset function which is set via the offset controls on the probe's compensation box to bring signals (those within the offset control range) into the dynamic range of the probe.
AC or DC coupling selection is available on the P6201 and P6202A FET Probes. When AC coupled, the DC voltage component is blocked, allowing viewing of superimposed signals.
A self-contained selectable 50 Ohm termination switch allows the P6201 or P6202A to be terminated into a 50 Ohm or 1 megaohm oscilloscope inputs.
Power for the P6201 and P6202A is supplied by the 400 Series, 2400 Series and 7000 Series mainframes through the optional Probe Power Jack or the 1101A Power Supply.
The P6201 or P6202A may also be used with other 50 Ohm and 1 megaohm input real-time oscilloscopes, sampling systems, spectrum analyzers and counters via the 1101A and appropriate interface adapters (SMA to BNC, GR to BNC, etc.).