The Sorensen DHP Series provides models ranging in output power from 5 kW to 20 kW in a single chassis. Programmable output voltages range from 5V to 50 VDC, delivering up to 3,000 amperes. This family has two operational modes, constant-voltage and constant-current.
The DHP Series uses control technology permits up to nine (9) steps per sequence with a maximum sequence duration of up to 27.75 hours.
This family has standard analog and a variety of combinations of IEEE-488.2, RS-232 and/or isolated analog input control interface options.
| M1 | 360-440 VAC, 47-63 Hz, three phase, 3-wire plus ground, Delta or Wye may be used |
| M10 | Both IEEE-488.2 and RS-232 |
| M11 | RS-232 and isolated analog programming |
| M12 | IEEE-488.2 and isolated analog programming |
| M14 | IEEE-488.2, RS-232 and isolated analog programming |
| M2 | 432-528 VAC, 47-63 Hz, three phase, 3-wire plus ground, Delta or Wye may be used |
| M51 | Isolated analog programming Input Voltage Options. This isolation allows users to control power supplies not connected to a common ground. In addition, in systems with high ambient noise or with large ground loop currents the control ground can be isolated from the power ground eliminating problems. |
| M8 | Internal RS-232 remote serial interface |
| M9D | Internal IEEE-488.2 interface |
| Form Factor |
|---|
| Rackmount |
| Connectivity |
|---|
| GPIB ( /M9D ) |
| RS232 ( /M8 ) |
| Current |
|---|
| 30 A |
| Power |
|---|
| 16500 W |
| Type |
|---|
| CV/CC |
| Voltage |
|---|
| 550 V |